Start your own group! All DESIGN 21 members have the ability to create organizations.
Create A Group
Education
57 Supporters
Well-being, Industrial Design
I'm still looking to reduce the unit cost of the product. Because of the injection molding (cost of mold), the cost is high. However, if this product is mass produced and distributed by U.S. government, the cost will be much lower than prototype cost analysis
Posted April 06, 2009
By shinwoo Her
Fields marked * are required
Is it possible to generate products that are sensuous and smart, beguiling and ethically grounded?
Join This GroupA Good Life 6 - Parsons The New School for Design
Contact A Good Life 6 - Parsons The New School for Design
http://www.parsons.edu/
Moderator: pbeirne
Just one Allumonde Ring...
Can sponsor an African, Thai or Indonesian orphan for The Education Program (TEP), allowing the child learning opportunities and keeping him or her off the streets .
